Research articlePublished 31 Jul 2022
Microhardness of Gypsum Submitted to Different Methods of Pouring and Storage
Abstract
Select any words in the title or abstract, or press this and choose a sentence.
Statement of Problem: Whether using different methods of pouring and storage will affect to the surface hardness of gypsum Type IV casts. Aim: To compare the surficial microhardness (Knoop) of gypsum Type IV submitted to different methods of pouring and storage. Material and Method: Seventy-five specimens were made with gypsum Type IV (Herostone, Coltene) and distributed in 5 groups (n=15). A metal device was fabricated to simulate the tray and standardize the impression procedures. A Polyvinyl Siloxane (PVS. Express XT, 3M ESPE) was manipulated according to the manufacturer's instructions. After the setting time, the impression was removed and cleaned with water, dried, and disinfected with 2% glutaraldehyde. The experimental groups formed were: 1) Control/15–the die was removed from the impression material 15 min after pouring the cast; 2) 4 hour – the die was removed from the impression material 4 h after pouring the cast; 3) 40°C–the die was removed from the impression material, and stored during 30 min at ≅ 37°C; 4) sulfate/K– the impression was immersed in 2% potassium sulfate solution during 5 min after the gypsum pouring and removed from the PVS after 15 min; 5) sulfate/Ca– the impression was immersed in 2% Ca sulfate solution during 5 min after gypsum was poured and removed from the PVS after 15 min. The microhardness test Knoop was performed at 3 different points. The average was used for the statistical analysis. The normality of the data was confirmed by Kolmogorov-Smirnov test (P=0.200). Statistical differences between groups were analyzed by one-way ANOVA. The details of the analysis were performed using the Dunnett test and the Tukey HSD test. All tests were performed with a significance level of 5%. Results: The lowest microhardness values were found in the Control group/15<4=40°C=sulfate/K= sulfate/Ca Conclusion: All the experimental treatment methods increased significantly the surface microhardness of the gypsum Type IV when compared to the control. Clinical relevance: Die treatments can improve the hardness of the gypsum die, preventing cast fracture.
Subjects
Dentistry & Oral HealthAsk about this article
Answers come only from this article's title, abstract and keywords, each sentence pointing to where it comes from. Your question is sent to OpenAI to write the answer. EuroSciCon does not store it.
Follow
New articles from what you follow go into your email digest, once you agree to alert emails.
- JournalJournal of General Dentistry
- SubjectDentistry & Oral Health
- BylineArticles whose byline prints “Greciana Bruzi”
- BylineArticles whose byline prints “Larissa Fernanda Pottmaier”
- BylineArticles whose byline prints “Luana Dutra de Carvalho”
